冷凍式空氣干燥機
◆產品特點 Product features
制冷及空氣系統,經專家準確計算,設計參數均留20%以上的余量。制冷壓縮機采用旋轉式或渦旋式、活塞式全封閉制冷壓縮機及半封閉螺桿式制冷壓縮機(20HP以上),運行穩定,噪音低,性能可靠,省電壽命長。能效比好,防護等級為IP54(防塵及防濺)
熱交換器、風冷凝器選用優質銅管帶純鋁鰭片,攏流結構換熱產率好、因而體積小,結構緊湊。筒體材料選用不銹鋼或碳鋼鍍鋅,可避免對壓縮空氣的二次污染。制冷控制元件性能優良。具有熱力膨脹閥的節流降壓功能,熱氣旁通閥的能量調節功能,過電流、過負載、冷媒高壓保護等功能。
氣液分離器采用旋風分離與不銹鋼絲網捕霧有機結合,具有氣液分離效果徹底,避免水份的二次蒸發,確保冷干機的干燥效果。它比旋風分離器性能好,同時又比過濾式氣液分離器使用成體低,具有性能價格比。水冷凝器為優質低翅銅管,慢水流、多沖程,換熱效率好,長期使用不宜結垢。自動排水器按需設置,除水加節能,效果好;浮球式,電子定時可選擇。外轉子冷風扇,大風量、低噪聲,頻繁啟停長壽命。
承壓部件設備結構設計合理,便于維護保養;表面熱噴塑,外形美觀,不生銹;無基礎安裝,運行平穩無振動,維修率低,無消耗品,運行費用少,連續運行無須專人守候。
Refrigeration and air system, the experts accurate calculation, design parameters are left more than 20% of the surplus. Refrigeration compressors adopt international advanced rotary or scroll type, piston enclosed refrigeration compressor and close partly screw refrigeration compressor (20 HP above), stable operation, low noise, reliable performance, save electricity long life. Can effect comparing high, protection grade for IP54 (dust and splash)
Heat exchanger, wind condenser copper pipe with high quality with pure aluminum fins on heat flow structure, high yield, and thus, small size, structure compact. The cylinder body materials selecting stainless steel or carbon steel galvanized, can avoid to compressed air of the secondary pollution. Refrigeration control elements adopt the most advanced Denmark danfoss (DANROSS) and the Persian LAN (SPORLAN), (ALCO) refrigeration components, excellent performance. Thermal expansion valve with the throttling step-down function, heat the by-pass energy adjustment function, over electric current, the load, cold media high voltage protection.
Liquid-vapor separator using whirlwind separation and stainless steel wire the organic combination of the trap with gas liquid separation effect of moisture, avoid completely secondary evaporation, ensure the blotting etc.is dry effect. It than cyclone separator performance is good, at the same time than a gas-liquid separator filter brand-newly type use adult, and has a low price is high performance. Water condenser copper pipe for high quality, low wing, stroke, slow flow in high thermal efficiency, use for a long time shoulds not be scaled. Automatic drainage device according to the needs, in addition to water and energy saving set, the effect is good; Float type, electronic timing can choose.The cold wind, big rotor fan air, low noise, long life. Stop frequent rev.
Parts are confined by national gb1501998 "steel pressure vessel" and GB151-1999 "tubular heat exchanger of manufacture, test and check and accept," pressure vessel safety technology supervision code "supervision. Equipment structure design is reasonable, facilitate maintenance; The surface heat spraying, beautiful appearance, not rust; No basis installation, smooth operation no vibration, maintenance rate is low, no consumables, operation cost less, without waiting for continuous operation special.
工況條件與技術指標 Working condition and technical indexes | |
進氣溫度 The inlet temperature |
常溫型≤50℃,高溫型≤80℃ |
冷卻方式 Cooling way |
風冷(水冷) |
環境溫度 Environment temperature |
≤40℃(風冷) |
壓力露點 Pressure dew point |
1.7℃~10℃(0.7 MPa) |
制冷劑 Refrigerants |
R-22或根據客戶要求可采用R134a,R404 a,R507等無氟環保制冷劑。 |
進氣壓力 The inlet pressure |
0.2~1.0MPa(6.4 MPa以下接受訂貨) |
壓力損失 The pressure loss |
≤0.02 MPa |
冷卻水進水溫度 Cooling water inlet water temperature |
≤32℃(水冷) |
冷卻水進水壓力 Cooling water feed water pressure |
0.15~0.4 MPa(水冷) |
◆主要技術參數 Main technical parameters
ADH |
-5F |
-10F |
-20F |
-30F |
-60F |
-75F |
-120F |
-150F |
-200F |
-250F |
-300F |
-400F | |
處理量 Capacity m3/min |
0.7 |
1.6 |
2.6 |
3.8 |
7.0 |
8.5 |
13.5 |
17 |
23 |
27 |
34 |
45 | |
工作壓力 Work pressure |
| ||||||||||||
露點溫度 Dew point temperature |
| ||||||||||||
制冷劑 Refrigerants |
R-12 |
| |||||||||||
電源 Power |
|
| |||||||||||
壓縮機功率 Compressor power(KW) |
0.18 |
0.28 |
0.6 |
0.75 |
1.1 |
1.3 |
2.2 |
2.9 |
3.7 |
4.8 |
5.5 |
7.5 | |
風扇電機功率 Fan motor power(W) |
30 |
170 |
170 |
180 |
300 |
300 |
510 |
510 |
600 |
720 |
900 |
1200 | |
接口尺寸 Interface size |
ZG1/2" |
ZG1" |
ZG1" |
ZG1.5" |
ZG1.5" |
ZG2" |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL | |
外形尺寸 Appearance and size |
長L(mm) |
530 |
800 |
800 |
800 |
1100 |
1100 |
1550 |
1400 |
1550 |
1800 |
1900 |
2000 |
寬W(mm) |
360 |
450 |
450 |
450 |
600 |
600 |
650 |
780 |
780 |
780 |
950 |
950 | |
高H(mm) |
490 |
970 |
970 |
970 |
1250 |
1250 |
1480 |
1580 |
1580 |
1580 |
1800 |
1800 | |
凈重 Weight(kg) |
50 |
95 |
100 |
100 |
210 |
250 |
350 |
470 |
550 |
650 |
800 |
1000 |